FREE
circuits!
Switches circuit diagrams
- 1
- 2
September 30, 2010
Due to the low current drawing, the circuit can be supplied from 230Vac mains without a transformer. Supply voltage is reduced to 12Vdc by means of C1 reactance, a two diode rectifier cell D1 &... [more]
circuit from:http://www.extremecircuits.net/2009/07/220v-ac-lamp-toggle-switch.html
September 30, 2010
A simple and convenient way to interface 2 relays for switching application in your project. This relay driver boosts the input impedance with a regular BC547 NPN transistor (or equivalent). Very common driver. It can... [more]
circuit from:http://www.extremecircuits.net/2010/01/dual-relay-driver-board-circuit.html
August 8, 2010
This simple circuit will energize and de-energize a relay at the push of a button. Pushing the button once - will energize the relay. And pushing it a second time - will de-energize the relay.... [more]
August 8, 2010
The Elect. Sel. 8 is a simple circuit, with a choice of 8 sources of any sort ,of 8 independent switches. Each switch corresponding with a relay for example the switch S1 activates the RL1... [more]
August 8, 2010
This is a circuit for alternative sources selection. It combines mechanical selection using a rotating switch S1, the electronic drive of the relays RL 1-10 and also the optical indication of the selection by the... [more]
August 8, 2010
It is useful where the load needs to be switched on from one location and switched off from another. Any number of momentary (N/O) switches or push buttons can be connected in parallel. [more]
August 8, 2010
This 555 timer circuit toggles a relay when a button is pressed. Pins 2 and 6, the threshold and trigger inputs, are held at 1/2 the supply voltage by the two 10K resistors. When the... [more]
August 8, 2010
This toggle circuit operates by using a couple 555 timers wired as inverters. Pins 2 and 6 are the threshold and trigger inputs to the first timer and pin 5 is the output. The output... [more]
August 8, 2010
The circuit requires a double pole, double throw relay in conjunction with a single transistor to allow toggling the relay with a momentary push button. One set of relay contacts is used to control the... [more]
August 8, 2010
In operation, when the relay is deactivated, the 100uF capacitor will charge to 6 volts. When the button is pressed, the capacitor will apply 6 volts to the MOSFET gate turning it on. The capacitor... [more]
- 1
- 2
This category