873
FREE
circuits!
FREE
circuits!
How to build Voltage Inverter II
October 5, 2010 - category: DC to DC converterDescription
This simple and inexpensive circuit can produce a dual (positive and negative) voltage from a single supply input. It is therefore extremely useful for powering opamp and other circuits that require a dual voltage from a single battery. The circuit will operate at an input voltage from around 5V to 20V and produce a output from +-2.5V to +-10V.
Circuit diagram
Parts
- R1 1M Linear Pot
- C1,C2 15uf 25V Electrolytic Capacitor
- U1 LM380 Audio Amp Chip
- MISC Heatsink For U1, Binding Posts (For Input/Output), Wire, Board
Notes
- 1. U1 dissipates around 1W and will therefore require a heatsink.
- 2. R1 is used to equalize the outputs. The first time you use the circuit, it should be set to mid range and then adjusted with the aid of a voltmeter. Measure each output while adjusting. The circuit is calibrated when both outputs read the same voltage (either positive or negative).
circuit from http://www.aaroncake.net/
This category