FREE
circuits!
LED and light circuit diagrams
October 12, 2010
This little circuit can be used to dim lights up to about 350 watts. It uses a simple, standard TRIAC circuit that, in my expirience, generates very little heat. Please note that this circuit cannot... [more]
October 12, 2010
This circuit enables observation of movement between other stroboscopes. Generation of rectangular signal is based on NE555. This circuit requires a low power supply that is made from a simple transformer TR1, traditional rectifier bridge... [more]
October 12, 2010
This circuit has been designed to provide that continuous light lamps already wired into a circuit, become flashing. Simply insert the circuit between existing lamp and negative supply. Especially suited for car or panel pilot... [more]
October 4, 2010
This circuit is similar to the LED clock using 12 neon indicator lamps instead of LEDs. It operates from 2 high capacity ni-cad cells (2.5 volts) which keep it going for a couple weeks. High... [more]
October 3, 2010
Here is a white-LED-based emergency light that offers the following advantages. 1-It is highly bright due to the use of white LEDs. 2-The light turns on automatically when mains supply fails, and turns off when... [more]
circuit from:http://www.extremecircuits.net/2010/01/automatic-low-power-emergancy-light.html
October 3, 2010
This circuit operates two LED strips in pulsing mode, i.e. one LED strip goes from off state, lights up gradually, then dims gradually, etc. while the other LED strip does the contrary. Each strip can... [more]
circuit from:http://www.extremecircuits.net/2010/01/fading-leds-circuit-diagram.html
October 3, 2010
This circuit was purposely designed as a funny Halloween gadget. It should be placed to the rear of a badge or pin bearing a typical Halloween character image, e.g. a pumpkin, skull, black cat, witch,... [more]
October 3, 2010
This circuit was designed as a warning flasher to alert road users to dangerous situations in the dark. Alternatively, it can act as a bicycle light (subject to traffic regulations and legislation). White LEDs only... [more]
circuit from:http://www.extremecircuits.net/2010/05/high-intensity-led-warning-flasher.html
October 2, 2010
This circuit operates a LED in pulsing mode, i.e. the LED goes from off state, lights up gradually, then dims gradually, etc. This operation mode is obtained by a triangular wave generator formed by two... [more]
circuit from:http://www.extremecircuits.net/2009/08/led-or-lamp-pulsar-circuit.html
October 2, 2010
This circuit was designed to provide that continuous light lamps already wired into a circuit, become flashing. Simply insert the circuit between existing lamp and negative supply. Especially suited for car or panel pilot lights,... [more]
circuit from:http://www.extremecircuits.net/2009/08/led-or-lamp-flasher-circuit.html
This category