873
FREE
circuits!

Light flasher circuit diagrams

pages:
Dancing LEDs
Dancing LEDs
November 11, 2010

The basic circuit illuminates up to ten LEDs in sequence, following the rhythm of music or speech picked-up by a small microphone. The expanded version can drive up to ten strips, formed by up to... [more]

LED Chaser
LED Chaser
October 31, 2010

This schematic is version of a simple 10 LED chaser. There is no 555 timer used because at my local electronics store they are over $4 Cdn. Instead, an oscillator made up of two sections... [more]

LED or Lamp Flasher
LED or Lamp Flasher
October 29, 2010

Minimum parts counting Designed for 3V battery operation [more]

LEDs or Lamps Sequencer
LEDs or Lamps Sequencer
October 29, 2010

The purpose of this circuit was to create a ring in which LEDs or Lamps illuminate sequentially. Its main feature is a high versatility: you can build a loop containing any number of LEDs or... [more]

LED or Lamp Pulser
LED or Lamp Pulser
October 27, 2010

This circuit operates a LED in pulsing mode, i.e. the LED goes from off state, lights up gradually, then dims gradually, etc. [more]

Adjustable Strobe Light
Adjustable Strobe Light
October 15, 2010

This one uses a much more powerful "horse shoe" Xenon tube which produces more light. You can also control the flash rate up to about 20Hz. Do not look directly at the flash tube when... [more]

Knightrider lights for model cars
Knightrider lights for model cars
October 15, 2010

This simple circuit drives 6 LEDs in 'Knightrider scanner mode'. Power consumption depends mainly on the type of LEDs used if you use a 7555 (555 CMOS version). [more]

Triple Stroboscope
Triple Stroboscope
October 12, 2010

This circuit enables observation of movement between other stroboscopes. Generation of rectangular signal is based on NE555. This circuit requires a low power supply that is made from a simple transformer TR1, traditional rectifier bridge... [more]

Two-wire Lamp Flasher
Two-wire Lamp Flasher
October 12, 2010

This circuit has been designed to provide that continuous light lamps already wired into a circuit, become flashing. Simply insert the circuit between existing lamp and negative supply. Especially suited for car or panel pilot... [more]

12 Stage Neon Sequencer (NE-2 / NE-51)
12 Stage Neon Sequencer (NE-2 / NE-51)
October 4, 2010

This circuit is similar to the LED clock using 12 neon indicator lamps instead of LEDs. It operates from 2 high capacity ni-cad cells (2.5 volts) which keep it going for a couple weeks. High... [more]



pages: