873
FREE
circuits!

How to build Simple Digital Volume Control

November 26, 2010 - category: Tone and volume control

Description

This digital volume control has no pot to wear out and introduces almost no noise in the circuit. Instead, the volume is controlled by pressing UP and DOWN buttons. This simple circuit would be a great touch to any home audio project.

Schematic:

Simple Digital Volume Control-Schematic

Parts:

  • C1 0.1uf Ceramic Disc Capacitor
  • U1 DS1669 Digital Pot IC (See Notes)
  • S1, S2 Momentary Push Button Switch
  • MISC Board, Wire, Socket For U1

Notes:

  • U1 is available from Dallas Semiconductor.
  • S1 turns the volume up, S2 turns it down.
  • The input signal should not fall below -0.2 volts.
  • Using a dual polariity power supply (+-5V works fine) will cure most clipping problems. You will have to check the data sheet for the correct pins to connect your voltages.







circuit from http://www.aaroncake.net/

If you liked this page please consider sharing. Thanks!


Bookmark and Share

Previous and next post from Tone and volume control