The amplifier of circuit, use negative current feedback. So, the load current depends mainly from the input signal and no so much from the impedance of loudspeaker. [more]
This is an audio power amplifier, with its final stage giving 40 W/8 Ω at Class A. The power transistors, are always ON , allowing a very high current to flow. [more]
This circuit was designed and manufactured the '80's. From then it works without problem. It does not present any particular constructional problem, beyond known: the attention in the provided force of power supply - choice... [more]
One still designing that it uses in the exit transistor of technology V-mosfet. This transistors to us offer a lot of virtues concerning the simple bipolar transistors, as high speeds, thermic stability, low distortion etc. [more]
Although the TDA2030 can deliver 20 watts of output power, I deliberately reduced the output power to about 8 watts to supply 10 watt speakers. Input sensitivity is 200mV. Higher input levels naturally will give... [more]
A small power amplifier, but with very good quality of sound. It combines a completed very good quality (NE5534), that has the possibility of control of low loads, high speed, low distortion and two transistors... [more]
It is a little collection of amplifiers in bridge connection. The output power is low and they are for general use. They can be used with small active loudspeakers, car stereos etc. The only restriction,... [more]
A opamp. medium power, here its used as amplifier of headphones with possibility drive low loads. It contains in a nutshell two amplifiers. [more]
Even if simple the circuit, plirej' all condition, regarding the distortion and the response of frequency. The resistance of entry is 250K and the load that can drive is between 100R and 2K. [more]
It is a very useful thing , to have a small headphone amplifier , capable of driving a couple of pairs phones. Fortunately, the headphone amp has a much easier job to do, in that... [more]